What is carton sealing machine?
Carton Sealing machine is a new-type and advanced pneumatic packing machine. Mainly used in carton enterprises and paper packaging production enterprises. This product is fit on carton packing machine, carton sealing machine, carton packing, hardware packing, stationery packing, aluminum material packing, etc. Fob Price is $600-$2500
Where is the carton sealer mainly used?
Due to its many advantages, box sealer machines are widely used in home appliances, electronics, food, dairy, oil, cosmetics, beverages, electrical appliances and other production professions. This kind of machine is one of the components of the active boxing production line. Its primary function is to replace the manual sealing of the product with the box.
How to repair case taper machine common faults?
1. The nail clamping action is too slow or the nail clamping stroke is insufficient:
The bolt is loose, and the front buckle or the inner plate of the trigger is worn. At this time, the bolt can be tightened, paying attention to the correct position of the front buckle shaft.
You can also replace the front buckle or the trigger inner film. After completing the above actions, test its function. If the stroke is too short, fine-tune the front buckle shaft upwards, and fine-tune the front buckle shaft downwards if the movement is slow;
2. Air leakage at the piston rod: The bottom ring of the main body is damaged. The ring should be replaced at this time.
3. Air leakage at the exhaust port: the switch valve ring or switch seat ring is damaged or the piston ring is damaged. Replace the ring.
4. Air leakage at the trigger: the switch valve ring or switch seat ring is damaged. Replace the ring.
5. The transmission ring is loose and cannot be positioned: the plastic steel bar and the transmission spring are inelastic. Remove the trigger assembly and reinstall the spring pin or replace the plastic steel bar and drive spring.
How to use case sealer?
1. Install and wind the tape, adjust the tape to the middle position.
2. Adjust the air pressure.
3. Check if there is water in the oil-water separator, drain the water; check if the amount of oil is sufficient, and if it is insufficient, add it.
4. Adjust the position of the side pressure roller.
5. Adjust the swing rod to the proper position.
6. Press the switch ON button to turn on the power and make the machine run.
7. Push the carton in from the input end of the machine (the sealing cover on the top of the box must be erected), and release it when it is driven by the conveyor belt. When the carton touches the rear flap control switch, the cylinder piston extends and pushes to fold back The cover is raised. When the carton completely passes through the rear flap control switch, the rear flap control switch is reset. At this time, the cylinder piston shrinks, and the rear flap falls, pressing the rear cover of the carton, and both sides of the carton are under the action of the swing lever. After completing the side cover folding action, the purpose of folding and sealing the box can be completed. Then the tape applicator completes the work of applying the tape.
8. The order of folding cover is: front cover, back cover, left and right side cover.
9. Press the OFF button of the switch, disconnect the power supply, and stop the machine.
In modern life, many products need to be packed into boxes and sealed, so the automatic box sealing machine is a good choice. It can change the manual packaging method, which can not only reduce the number of labour, but also save time, and the packaging quality is better than traditional The manual sealing should be excellent.
Shuntain was established in 1999 and has 20 years of production experience. If you are a terminal factory and plan to upgrade the packaging machine production line, please contact us. We can provide you with the corresponding one-stop packaging solution. Or you, as a trader, want to make corresponding profits through the sealing machine, you can be our brand distributor abroad. We will cooperate with you at any time in the spirit of win-win cooperation.
The box taper produced by Shuntian can maximize maintenance work and provide effective manual alternatives. The unique design of the system has been regarded by customers as the best machine.