Introduction to the correct operation procedure of heat shrinkable laminator

1.The operator must read the instructions carefully before using the equipment, and then operate after confirming that the equipment has been mastered.
2.Check the input power (AC220V) of the heat shrinkable laminator and the grounding.
3.Close the input switch and adjust its speed knob to the middle slow speed position.
4.adjust the heating temperature (can be set at about 130 ° first) and then close the heating switch, the machine starts to heat.
5.Close the hot air switch, the circulating air starts to work; after the standby device reaches the set temperature, shrink packaging is performed at this time.

6.In actual operation, if there are more wrinkles after shrinking, you can reduce the speed or increase the temperature; if there is excessive shrinkage, you can lower the temperature or increase the speed. In short, according to the actual size of the packaged items, packaging materials, etc., the temperature and speed are adjusted to achieve the perfect shrinkage and beautiful packaging.
7.When the machine is working, it is strictly forbidden to reach into the machine to avoid hot and electric shock.
8.In the process of operation, if abnormality is found, it should be stopped immediately and checked. After the fault is removed, it can be used continuously; if the fault cannot be eliminated, the operator should report to the management department in time to prohibit the equipment from running with fault.
9.After using the heat shrinkable laminator, the three sets of heating switches should be turned off, so that the conveying motor and the fan continue to run for about ten minutes before cutting off the power. Timely cleaning and finishing items. And the daily maintenance of the equipment should be carried out in accordance with the Equipment Management System.